Verify NSX-T v2.5 Installation
Page last updated:
Warning: VMware Enterprise PKS v1.6 is no longer supported because it has reached the End of General Support (EOGS) phase as defined by the Support Lifecycle Policy. To stay up to date with the latest software and security updates, upgrade to a supported version.
This topic provides instructions for verifying your NSX-T environment after performing an installation of NSX-T v2.5.
Prerequisites
Make sure you have completed all preceding NSX-T installation tasks.
Verify the Installation of NSX-T v2.5
Complete the following operation for each ESXi host to be used by the PKS Compute Cluster.
In NSX-T Manager, create a T0 router.
- Name: T0-router
- Edge Cluster: edgecluster1
- HA mode: Active/Standby
Create a router port.
- Transport Node: edge-node-1
- LS: T0-uplink-LS
- Subnet: For example, 10.40.206.10/25
Click Save to create the T0 router.
Create a static route.
- Network: 0.0.0.0/0
- Next hop: 10.40.206.125
Click Save to save the T0 router.
Verify that you can ping the T0 interface IP from the network.
PING 10.40.206.10 (10.40.206.10): 56 data bytes 64 bytes from 10.40.206.10: icmp_seq=0 ttl=55 time=24.407 ms 64 bytes from 10.40.206.10: icmp_seq=1 ttl=55 time=23.984 ms 64 bytes from 10.40.206.10: icmp_seq=2 ttl=55 time=24.170 ms 64 bytes from 10.40.206.10: icmp_seq=3 ttl=55 time=30.211 ms
Next Step
Assuming you have successfully completed all preceding NSX-T installation tasks, NSX-T Data Center is now be installed and configured for Enterprise PKS.
Depending on your requirements, you may want to complete the following additional tasks:
- The NSX-T Data Center administrator password expires after 90 days. To change the password or the expiration interval, see Updating the NSX-T Admin Password.
- If you require scalability for the NSX Management Cluster, Provision a Load Balancer for the NSX-T Management Cluster.
Installation Instructions Home
See Installing and Configuring NSX-T v2.5 for Enterprise PKS.
Please send any feedback you have to pks-feedback@pivotal.io.